Editing Text Parameters Using The Traditional Method; Figure 3-8 The Character Cycle Of The Traditional Text Edit Method - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
7. If you want to cancel the editing operation and return to the original parameter
value, on the virtual keyboard, highlight CANCEL, and then press [ENTER].
8. To complete the editing of the parameter value, on the virtual keyboard, highlight
DONE, and then press [ENTER].
NOTE
When editing a multiple line parameter value, highlighting DONE and pressing
[ENTER] moves the cursor to the next line. You can also press [2nd F], [] to accept
the text and move the cursor to the next line.
3.4.2

Editing Text Parameters Using the Traditional Method

When the text edit mode is set to TRADITIONAL, you select each character from a
hidden circular list of standard sorted letters, numbers, and special characters (see
Figure 3-8 on page 46). Only upper case letters are available.
Figure 3‑8 The character cycle of the traditional text edit method
46 Chapter 3
[]
Cycling begins at "A" when the
original character is a letter
Cycling begins at "0" when the
original character is a digit
[]