Figure 9-3 Changing The Communication Parameters - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Figure 9‑3 Changing the communication parameters
a) In COMM PROTOCOL, select which remote command set the instrument
uses for communication:
○
MULTI CHAR: Multi character commands used for communication with
a computer running the GageView interface program.
○
SINGLE CHAR: Single character command normally used when an
external program is controlling the instrument by remotely sending
commands to mimic keystroke.
b) In OUTPUT FORMAT, select the format of the data being output (F1, F2,
F3,...F10). Refer to Table 24 on page 258 and Table 25 on page 259 for the
description of available output formats.
NOTE
Contact Olympus for more information on the following communication parameters:
• Multi and single character remote commands.
• Send formats (F1, F2, F3, F4, F5, F6, F7, F8, F9, and F10).
c) Set DATABASE TRACKING to ON to allow the instrument to track the
measurement parameters (calibration settings, transducer type, gain etc.) that
were used in a previous inspection. In order for this feature to be
implemented, you must load the previous inspected file to the 38DL PLUS
132 Chapter 9