Active Measurement; Using The Multi-Measurement Normal Mode; Figure 7-6 Waveform Display Screen - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Transducer Setups" on page 211 for information about creating custom setups. All
custom setups included in the multi-measurement configuration must use the same
PROBE TYPE.
7.4.1

Active Measurement

With the multi-measurement, one of the displayed measurement is the active
measurement. The value of the active measurement is highlighted and is repeated at
the bottom of the screen. The corresponding waveform appears in the waveform
display (see Figure 7-6 on page 100).
Waveform
corresponding to the
active measurement
Active measurement
value
To change the active measurement
1. Enable the multi-measurement mode (see "Using the Multi-Measurement with
the Soft Contact Mode" on page 102).
2. Use the arrows keys to change the active measurement.
7.4.2

Using the Multi-Measurement Normal Mode

Use the multi-measurement normal mode unless you want to show thickness values
as a percentage of the total thickness or when you want to inspect soft contact lenses.
100 Chapter 7
Figure 7‑6 Waveform display screen