Table of Contents
Advertisement
DMTA-10004-01EN, Rev. D, November 2016
7.
In the SAVE SETUP screen:
a) If needed, in SAVE AS, edit the setup name.
b) In the SAVE TO list, select the desired custom setup location where you want
to the save the setup.
c)
Select SAVE.
8.
Press [MEAS] to return to the measurement screen.
The saved setup becomes the active setup.
13.2 Quickly Adjusting Waveform Parameters For Single Element
Transducers
With single element transducers, you can quickly adjust individual waveform
parameters using the [WAVE ADJ] key.
To quickly adjust individual waveform parameters
1.
Ensure that a single element transducer is connected to the 38DL PLUS.
2.
From the measurement screen, press [WAVE ADJ].
The waveform adjustment parameter appears on the measurement screen above
the thickness value (see Figure 13-2 on page 224).
Waveform parameter
224
Chapter 13
Figure 13‑2 Adjusting the waveform parameters
Waveform parameter
value
Advertisement
Chapters
Table of Contents
Troubleshooting
