Figure 11-28 Editing The Id # Edit Mode - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
To use the ID edit mode
1. Open the file in which you wish to edit an ID (see "Opening a File" on page 184).
2. From the measurement screen, press [ID#].
3. Select the ID you wish to edit (see "Reviewing Stored Data and Changing the
Active ID" on page 199).
4. Press [ID#] again, and edit the ID value (see Figure 11-28 on page 200).
5. Press [MEAS] to return to the measurement screen with the new active ID.
6. When the edited ID is not in the database, the help text bar message shown in
Figure 11-29 on page 201 appears, select INSERT to insert the new ID before the
active ID.
OR
Select APPEND to add the new ID at the end of the file.
200 Chapter 11
Figure 11‑28 Editing the ID # edit mode