3-D Custom File Type; Figure 11-13 Configuring The Id Range For A Boiler Data File Type; Table 18 Resulting Id Example For The 3-D Custom File Type - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
Figure 11‑13 Configuring the ID range for a boiler data file type
11.2.1.8

3-D Custom File Type

The 3-D custom file type is very similar to a standard 3-D Grid except that the point
parameter can be a custom list of points.
Table 18 on page 180 shows an example where the custom point increments first, the
custom row second, and the column third.
Table 18 Resulting ID example for the 3‑D CUSTOM file type
Parameters
START COLUMN
END COLUMN
To create a 3-D custom data file
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see "Creating a Data File" on page 163 for details on the first parameters).
180 Chapter 11
CUSTOM
Value
ROWS
A -TOP-
F -MIDDLE-
-BOTTOM-
CUSTOM
Resulting IDs
POINTS
LEFT A-TOP-LEFT
RIGHT A-TOP-RIGHT
A-MIDDLE-LEFT
A-MIDDLE-RIGHT
...
F-BOTTOM-LEFT
F-BOTTOM-RIGHT