Generating Reports - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
TIP
To replace a thickness reading, it is easier to save a new measurement at the desired
ID from the measurement screen. If you do not want to save a measurement at a
specific ID, press [SAVE/SEND] from the measurement screen when you are not
taking a measurement. This stores an LOS condition and —-.—- at the specific ID
number.
4. Press [MEAS] to return to the measurement screen.
NOTE
When deleting the measurement stored in an ID, the ID is also deleted. In all other file
types, only the thickness and waveform data is deleted.

11.7 Generating Reports

The 38DL PLUS can generate inspection data reports without having to connect to a
computer or printer. The following reports are available:
File summary
Shows basic statistics for the file (minimum thickness and location, maximum
thickness and location, high and low alarm conditions along with the mean,
median, and standard deviation).
Minimum/Maximum summary
Shows a list of ID number location that have the minimum and maximum
thickness in a file.
Alarm summary
Shows a list of all the ID number locations where a low alarm and high alarm
occurred.
File comparison
Allows you to select two files and compare them. The first file contains the
previous inspection data and the second file contains the current inspection data.
The report indicates the maximum wall loss and any area of greater wall
thickness (growth) and their ID number locations.
202 Chapter 11