Figure 2-6 Attaching A Ferrite Clamp Filter To A Cable (Example Shown With The Scanner Interface Cable) - Olympus OmniScan MX User Manual

3. Attach the ferrite clamp filter to the USB cable, in close proximity to the connector
for the OmniScan MX2.
4. Attach the ferrite clamp filter to the Ethernet cable, in close proximity to the
connector (RJ-45) that connects to the OmniScan MX2.
5. Attach the ferrite clamp filter to the scanner interface cable, in close proximity to
the connector (LEMO) for the OmniScan MX2.
6. Attach the ferrite clamp filter to the alarm and I/O cable, in close proximity to the
connector (DE-9) for the OmniScan MX2.
Figure 2-6 on page 47 and Figure 2-7 on page 48 show the applicable connection for
various cables on the OmniScan MX2, and the locations where the ferrite clamp filters
must be attached.
Figure 2-6 Attaching a ferrite clamp filter to a cable (example shown with the
DMTA-20015-01EN [U8778402], Rev. M, February 2017
scanner interface cable)
Basic Operation 47