Concluding Steps; Replacing A Riser Card; Preliminary Steps - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

8.5.5.6

Concluding steps

"Reassembling" on page 73
Ê
Ê Connect all external cables to the replaced expansion card.
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
"Enabling replaced components in the system BIOS" on page 115
Ê
Ê If applicable, inform the customer about changed WWN and MAC
addresses. For further information, refer to section
MAC / WWN addresses" on page
Ê If applicable,"Updating RAID controller firmware" on page
"Enabling SVOM boot watchdog functionality" on page 114
Ê
"Resuming BitLocker functionality" on page 120
Ê
8.5.6

Replacing a riser card

Upgrade and Repair Unit
(URU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / nut driver 5 mm
8.5.6.1

Preliminary steps

"Suspending BitLocker functionality" on page 95
Ê
"Disabling SVOM boot watchdog functionality" on page 96
Ê
"Locating the defective server" on page 61
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting the power cord" on page 66
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 68
Ê
Ê If applicable, disconnect internal cables to the expansion card.
RX2540 M2
122.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Looking up changed
Hardware: 5 minutes
Software: 5 minutes
106.
279