Getting Access To The Component; Extending The Server Out Of The Rack - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Basic hardware procedures
4.4

Getting access to the component

V
CAUTION!
Only for non-hot plug components:
●
Before removing or attaching covers, turn off the server, all peripheral
devices, and any other connected devices. Because there is a risk of
electric shock or damage, please disconnect all power cords from the
outlet.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
For further safety information, please refer to chapter
●
information" on page
4.4.1

Extending the server out of the rack

V
CAUTION!
Use the anti-tilt plate to prevent the rack from tipping when installing
●
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
Be careful not to pinch fingers or clothes when sliding out the server
●
or pushing it back. Failure to do so may cause injury.
For further safety information, please refer to chapter
●
information" on page
68
49.
49.
Upgrade and Maintenance Manual
"Important
"Important
RX2540 M2