Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 589

Pos. Label
6
iRMC-related status signals
ID indicator
blue flashing
blue flashing
I
For further information please refer to section
the iRMC" on page
RX2540 M2
Indicator Status
green on
AC
connected
indicator
off
Global error
indicator
off
orange flashing
104.
Upgrade and Maintenance Manual
Description
– The server is switched off and
connected to the mains
(standby mode).
– The server has been switched on
but Power Cycle Delay settings
delay it from turning on for a
specified time.
I
After connecting the server to
the mains, it will take about
60 seconds until the server
will enter standby mode and
can be switched on.
– The server is switched off and
not connected to the mains.
– The server is switched on and
operating normally.
Description
A remote connection has been
established. Local VGA output has
been disabled during the remote
session.
An emergency flash of the iRMC
firmware is in progress.
"Updating or recovering
Appendix
589