Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 595

I
For further details on detected errors, refer to the System Event Log
(SEL) or use the ServerView Operations Manager or iRMC S4 web
interface.
iRMC-related status signals
ID indicator
blue flashing
blue flashing
I
For further information please refer to section
the iRMC" on page
HDD prefailure detection
Depending on your hardware configuration HDD prefailure detection will be
supported.
The requirements are:
– iRMC Firmware 7.14 or later
– supported OOB RAID system
– RAID controllers, which are not listed in the table below
RAID controllers that do not support HDD prefailure detection
D2616/MegaRAID SAS 9280-8e
D3116/D3116C
Table 8: RAID controllers that do not support HDD prefailure detection
RX2540 M2
Global error
indicator
off
orange flashing
104.
Upgrade and Maintenance Manual
Description
A remote connection has been
established. Local VGA output has
been disabled during the remote
session.
An emergency flash of the iRMC
firmware is in progress.
"Updating or recovering
MegaRAID SAS9285CV-8e
D2607
Appendix
595