Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 548

System board and components
I
Before removing the expansion cards, take a note on the installation
slot number for each card. Make sure that you reinstall the card in the
slot it was located before the replacement.
Ê Remove the DynamicLoM module (if applicable), see section
DynamicLoM module" on page 337
place of the LoM module.
Ê Remove the UFM (if applicable), see section
page 520.
I
Remove the UFM spacer from the defective system board and fasten
it to the UFM board with the UFM screw.
Ê Remove the SATA DOM (if applicable), see section
DOM" on page
Ê Remove the iRMC microSD card (if applicable), see section
iRMC microSD card" on page
548
539.
543.
Upgrade and Maintenance Manual
or the three screws that are installed in
"Removing the UFM" on
"Removing the SATA
"Removing the
"Removing the
RX2540 M2