4.4.4
Removing the air duct
Figure 7: Removing the air duct
V
CAUTION!
Be careful with the FBU cable.
If there is an FBU installed, follow the procedure that is described in
section
"Removing the FBU holder from the air duct" on page 322
Ê Remove the air duct vertically upwards (see arrow).
4.5
Reassembling
V
CAUTION!
Before attaching the covers, make sure no unnecessary parts or tools
●
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
●
electromagnetic compatibility) and satisfy cooling requirements, the
server must not run while the top cover is removed.
For further safety information, please refer to chapter
●
information" on page
RX2540 M2
49.
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
first.
73