Removing The Defective Hot-Plug Psu; Installing The New Hot-Plug Psu; Concluding Steps - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Ê Hold the CMA stopper, the crossbar and the CMA including cables in the one
hand.
Ê Remove the PSU (see figure 39) and install the new PSU carefully.
I
Note for PSU1: Remove the PSU1 carefully while lifting PSU1 and
bringing PSU1 to the right, in order to avoid interference
Ê Mount the complete assembly (CMA stopper, the crossbar and the CMA)
again into the rail.
6.4.3

Removing the defective hot-plug PSU

Ê Remove the defective PSU as described in
page 138.
6.4.4

Installing the new hot-plug PSU

Ê Install the new hot-plug PSU as described in section
PSU" on page
6.4.5

Concluding steps

"Connecting the power cord" on page 79
Ê
Ê Only when replacing a PSU in a non-redundant configuration:
the server" on page
"Performing a fan test" on page 126
Ê
RX2540 M2
134.
82.
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Removing a hot-plug PSU" on
"Installing a hot-plug
"Switching on
141