Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 69

Figure 4: Extending the server out of the rack
Ê Remove all remaining external cables from the rear connector panel and
expansion cards (see section
I
Note for installations with expansion cards in slot 5 and slot 11!
If there is a cable installed to an expansion card in the upper slot, see
section
11" on page
Ê If you are not using a cable mounting arm (CMA kit), ensure that the rear
cables are long enough not to be strained or damaged when extending the
server out of the rack.
Ê Fold down the two quick release levers on the rack mounting frame (1) and
pull the server out of the rack until it locks in place (2).
V
CAUTION!
Do not use the extended server as a surface on which to put things or as
a work surface, and strictly avoid leaning on or against it.
RX2540 M2
"Connectors and indicators" on page
"Note for installation with expansion cards in slot 5 and slot
83.
Upgrade and Maintenance Manual
Basic hardware procedures
582).
69