Shutting Down The Server - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

4.2

Shutting down the server

V
CAUTION!
For further safety information, please refer to chapter
information" on page
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Perform the required procedures described in the preliminary steps of each
upgrade or maintenance task.
"Verifying and configuring the backup software solution" on page
Ê
Ê In case of Multipath I/O environments, please refer to section
server maintenance in a Multipath I/O environment" on page
"Removing backup and optical disk media" on page
Ê
Ê Shut down the server.
I
If the system is running an ACPI-compliant operating system,
pressing the On/Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section
RX2540 M2
49.
"Locating the defective server" on page
Upgrade and Maintenance Manual
Basic hardware procedures
"Important
"Note on
100.
99.
99.
61.
65