7.2.3.3
Installing a 3.5-inch dummy module
V
CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 49: Installing a 3.5-inch dummy module
Ê Slide the 3.5-inch dummy module into the drive bay until it locks in place (1).
Ê Insert the lock (2).
I
Insert the lock only when there is no backplane behind this bay.
7.2.3.4
Concluding steps
Ê Refer to the RAID documentation configuring the RAID, see
you need at hand" on page
RX2540 M2
Hard disk drives (HDD) and solid state drives (SSD)
46.
Upgrade and Maintenance Manual
"Documents
153