Removing An Expansion Card From Riser Module 2; Preliminary Steps - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Expansion cards and backup units
"Reassembling" on page 73
Ê
Ê Connect all external cables to the expansion card(s).
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
Ê If applicable, "Updating RAID controller firmware" on page
Ê If applicable, "Enabling Option ROM scan" on page
"Enabling SVOM boot watchdog functionality" on page 114
Ê
"Resuming BitLocker functionality" on page 120
Ê
8.5.4

Removing an expansion card from riser module 2

Upgrade and Repair Unit
(URU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / nut driver 5 mm
8.5.4.1

Preliminary steps

Ê If applicable, "Locating the defective server" on page 61
"Suspending BitLocker functionality" on page 95
Ê
"Shutting down the server" on page 65
Ê
Ê Remove all external cables from the expansion card to be removed.
I
If there is a cable installed to an expansion card in the upper slot, see
section
11" on page
"Disconnecting the power cord" on page 66
Ê
"Getting access to the component" on page 68
Ê
Ê If applicable, disconnect internal cables from the expansion cards.
Ê If applicable, "Removing an SFP+ transceiver module" on page
Ê Remove the riser module 2 as described in section
module 2 (HL)" on page 87
274
"Note for installation with expansion cards in slot 5 and slot
83.
Upgrade and Maintenance Manual
106.
107.
Hardware: 5 minutes
Software: 5 minutes
"Removing the riser
252.
RX2540 M2