Disconnecting Cables From The Backplane; Removing The Backplane; Installing The Backplane; Connecting Cables To Backplane 2/3 - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)
7.5.2.2

Disconnecting cables from the backplane

Ê Disconnect all cables from the backplane as described in section
"Disconnecting cables from backplane" on page
7.5.2.3

Removing the backplane

Ê Remove the backplane as described in section
on page 203.
7.5.2.4

Installing the backplane

Ê Install the backplane as described in section
page 204.
7.5.2.5

Connecting cables to backplane 2/3

Configuration without SAS expander board
Figure 108: Connecting cables with SAS controller 2
Ê Connect the two SAS cables to the backplane 2:
– (1) from SAS controller 2 connector MLC1
208 Upgrade and Maintenance Manual
202.
"Removing the backplane"
"Installing the backplane" on
Controller 2
RX2540 M2