Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 309

Ê Install the air duct as described in section
8.6.4.9 Concluding steps
"Reassembling" on page 73
Ê
"Connecting the power cord" on page 79
Ê
"Switching on the server" on page 82
Ê
"Resuming BitLocker functionality" on page 120
Ê
8.6.5 Replacing GPGPU cards in riser modules
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver / nut driver 5 mm
8.6.5.1 Preliminary steps
Ê If applicable, "Note on network settings recovery" on page
"Suspending BitLocker functionality" on page 95
Ê
"Disabling SVOM boot watchdog functionality" on page 96
Ê
"Locating the defective server" on page 61
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting the power cord" on page 66
Ê
"Getting access to the component" on page 68
Ê
Ê If applicable, disconnect internal cables from the GPGPU card.
Ê Locate the defective GPGPU card using the onboard Local Diagnostic LEDs
as described in section
RX2540 M2
"Onboard indicators and controls" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the air duct" on page
Hardware: 10 minutes
Software: 5 minutes
74.
261.
584.
309