Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 556

System board and components
I
If Global Error LED is flashing with error message CPU has been
changed on display after the system is powered on, please follow the
procedure below.
Ê Restart your server.
Ê As soon as the startup screen appears, press the [F2] function
key to enter the BIOS.
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the LED stops flashing.
"Updating or recovering the system board BIOS and iRMC" on page 103
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility Reference Manual.
"Verifying system information backup / restore" on page 105
Ê
Ê If customer BIOS settings are not restored automatically, please change the
settings manually (using the information collected during "preliminary
steps"). If you couldn't determine the BIOS version, ask the customer to
reconfigure all BIOS settings and password.
"Verifying the system time settings" on page 116
Ê
"Looking up changed MAC / WWN addresses" on page 122
Ê
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 118
"Enabling SVOM boot watchdog functionality" on page 114
Ê
"Resuming BitLocker functionality" on page 120
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section
network settings recovery" on page 547
configuration" on page
556
335.
Upgrade and Maintenance Manual
"Note on
and section "Software
RX2540 M2