Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 288

Expansion cards and backup units
For all GPGPUs
Figure 183: Installing a GPGPU card in a riser module
Ê Fasten the GPGPU card with two screws (see circles).
8.6.1.5 Replacing the heat sink (FL)
Ê Replace the standard CPU heat sink with the CPU heat sink for GPGPU
card as described in section
8.6.1.6 Removing the slot cover riser module 1
Ê Remove the slot cover as described in section
module 1" on page
8.6.1.7 Removing the rear air grid riser module 1
Ê Remove the rear air grid as described in section
riser module 1" on page
288
"Replacing CPU heat sinks" on page
267.
268.
Upgrade and Maintenance Manual
"Removing the slot cover riser
"Removing the rear air grid
388.
RX2540 M2