Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 381

10.4 Upgrading or replacing CPUs
Field Replaceable Unit
(FRU)
Tool: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
CPUs are extremely sensitive to electrostatic discharge and must be
handled with care. After a CPU has been removed from its protective
sleeve or from its socket, place it upside down on a nonconducting,
antistatic surface. Never push a CPU over a surface.
10.4.1 Preliminary steps
"Suspending BitLocker functionality" on page 95
Ê
"Disabling SVOM boot watchdog functionality" on page 96
Ê
"Locating the defective server" on page 61
Ê
"Shutting down the server" on page 65
Ê
"Disconnecting the power cord" on page 66
Ê
"Getting access to the component" on page 68
Ê
"Removing CPU heat sinks" on page 387
Ê
10.4.2 Upgrading or replacing a CPU
I
This description applies to the following procedures:
– Installing the second CPU in a 1 CPU configuration
– Transfering a CPU after replacing the system board (see section
"System board" on page
– In case of installing a second CPU remove the protective cover as described
in section "Opening the load plate" on page
RX2540 M2
545)
Upgrade and Maintenance Manual
Processor (CPU)
Hardware: 15 minutes
Software: 5 minutes
364.
381