Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 296

Expansion cards and backup units
8.6.2 Removing a GPGPU card from riser module 1
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver / nut driver 5 mm
8.6.2.1 Preliminary steps
"Suspending BitLocker functionality" on page 95
Ê
"Shutting down the server" on page 65
Ê
Ê If applicable, remove all external cables from the expansion card to be
removed.
I
If there is a cable installed to an expansion card in the upper slot, see
section
11" on page
"Disconnecting the power cord" on page 66
Ê
"Getting access to the component" on page 68
Ê
Ê If applicable, disconnect internal cables from the GPGPU card.
296
"Note for installation with expansion cards in slot 5 and slot
83.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
RX2540 M2