Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual page 308

Expansion cards and backup units
8.6.4.4 Removing the air grid extension from riser module 2 (FL)
Figure 205: Removing the air grid extension from riser module 2
Ê Remove the two screws (see circles).
Ê Remove the air grid extension in the direction of the arrow.
8.6.4.5 Removing a GPGPU card
Ê Remove the GPGPU card as described in section
card (FL)" on page
8.6.4.6 Installing the slot cover riser module 2
Ê Install the slot cover as described in section
module 2" on page
8.6.4.7 Installing the rear air grid riser module 2
Ê Install the rear air grid as described in section
module 2" on page
8.6.4.8 Installing the air duct
I
If no GPGPU card is installed in riser module 2 you have to order a new
air duct to direct the airflow directly onto the CPU heat sinks and memory
slots.
308
298.
276.
276.
Upgrade and Maintenance Manual
"Removing a GPGPU
"Installing the slot cover riser
"Installing the rear air grid riser
RX2540 M2