Removing The Riser Module 2 (Hl) - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

Figure 19: Installing the riser module 1 (B)
Ê Fasten the riser module with five screws (see circles).
Ê If applicable, install SFP+ transceiver modules into the new expansion card,
as described in section
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
Ê If applicable, connect an FBU cable to the expansion card as described in
section "Connecting the FBU to the RAID controller" on page
4.8.1.3

Removing the riser module 2 (HL)

Ê If applicable, "Removing an SFP+ transceiver module" on page
RX2540 M2
"Installing SFP+ transceiver modules" on page
559.
Upgrade and Maintenance Manual
Basic hardware procedures
"List of used
318.
249.
252.
87