Installing A 2.5-Inch Dummy Module - Fujitsu PRIMERGY RX2540 M2 Upgrade And Maintenance Manual

7.4.3.3

Installing a 2.5-inch dummy module

V
CAUTION!
If the removed HDD/SSD module is not replaced immediately, always
replace a dummy module into the unused HDD/SSD bay to comply with
applicable EMC regulations and satisfy cooling requirements.
Figure 98: Installing a 2.5-inch dummy module
Ê Push the dummy module into the empty bay until it engages.
Figure 99: Installing dummy lock
I
For 8x 2.5-inch HDD/SSD version and 8x 2.5-inch HDD/SSD + 4x PCIe
SSD it is necessary to install the dummy locks to all unused HDDs bays
that means without a backplane behind the bay (8 pieces or 4 pieces).
RX2540 M2
Hard disk drives (HDD) and solid state drives (SSD)
Upgrade and Maintenance Manual 199