Connecting Communications - Christie roadie 25k User Manual

INSTALLATION AND SETUP
2.6 Connecting
Communications
Remote Keypads
2-28
Roadie 25K User's Manual
As an alternative to the projector's keypad or remote, you may wish to communicate
with the projector using a PC or other controller. Such a device sends commands and
receives feedback via serial links (2 types), Ethernet or GPIO communications, all
described below.
'
As desired, direct the projector's IR remote keypad towards the display screen or the
projector's IR sensors. Alternatively, connect a wired (tethered) version of the remote
to either the 3-pin XLR connector rear (standard) or the 3.5mm phono jack on the
side of the projector, depending on which type of cable you are using with this
remote. Note that response to a wired keypad must also be enabled in the
Communications menu—see 3.8, Adjusting System Parameters and Advanced
Controls for more information.
Note that if both wired remotes are connected, communications via the side input
have priority over communications via the rear.