Resuming Projector Operation After An Ac Power Interruption; Keeping Electronics On In Standby Mode; Implementing Stealth Mode - Christie Crimson Series User Manual

• Every time the user account password is updated, the generated password is changed.
• If the projector defaults are reset using either the Reset Projector Defaults or Reset
Factory Defaults features, the user account password is reset.
This feature is accessed from the display panel on the projector and the on-screen display.
1. From the display panel, select MENU > Admin > Service.
2. Enter the service password.
3. Select Generated password.
The generated password is displayed in this field.
Resuming projector operation after an AC power
interruption
If an AC power interruption occurs while Auto Power Up is enabled, the projector will resume operation
in the same state it was prior to the loss of power.
1. Select MENU > System Settings > Power Settings.
2. Select Auto Power Up.
3. To enable automatically powering up the projector after an AC interruption, select Enter.

Keeping electronics on in standby mode

When the projector is placed in standby mode, the light source will be turned off but the electronics
and required fans remain on.
1. Select MENU > System Settings > Power Settings.
2. Select Keep Electronics On In Standby.
3. To enable electronics remaining on in standby mode, select Enter.

Implementing Stealth mode

When Stealth mode is enabled, the status and shutter LEDs are turned off and the heartbeat feature
on the display panel Enter key is disabled.
1. Select MENU > System Settings > Power Settings > Stealth Mode.
2. To disable the LEDs and heartbeat feature, select Enter.
3. To enable the LEDs and heartbeat feature, select Stealth Mode again.
Crimson Series User Guide
020-102649-07 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring system settings
40