Ash Tray; Smoke Detector - KAMAZ 5490 Operation Manual

ASH TRAY

Installation of ash tray is possible in the cab.
To open pull the ash tray by the handle in the di-
rection of the arrow until stop (see Fig. Ash tray). Further
press the lock release button 2 and, holding it down, fully
pull the ash tray 1 out.
2
1

SMOKE DETECTOR

Smoke detector gives alarm signal in case of the
cab smoke blanketing. Detector can activate having
identified the particles of cigarette smoke, dust or ex-
haust gases.
Smoke detector is located over the driver's door
(see Fig Smoke detector).
Ash tray
1 - ash tray;
2 - lock release button
4-39
1
2
Warning sounds as a pulsating signal. Sound sig-
nal can be switched on by short pressing of operation
button. From the moment of pressing the button the
smoke alarm deactivates roughly for 20 min. When the
signal is switched off roughly every 40 sec. a short audio
signal sounds.
Control
of smoke detector operation
It is recommended to check serviceability of the
smoke detector once a week: press the operating button
and hold it down for 5-10 sec. If detector is fault free the
signal sounds. From the moment of pressing the button
the smoke alarm deactivates roughly for 20 min.
When batteries discharge a short signal sounds
roughly in every 40 sec. To provide the work of the
smoke detector change the battery.
Smoke detector
1 - operating button;
2 - lock release button