Mode For Diagnostics Of Operational Parameters - KAMAZ 5490 Operation Manual

MODE FOR DIAGNOSTICS
OF OPERATIONAL PARAMETERS
The diagnostics of operational parameters can be
used in case of remote malfunction diagnostics per-
formed by KAMAZ PTC specialists or by experts of ser-
vice centers.
To determine the type of malfunction when per-
forming diagnostics of operational parameters in vehicle
systems the display shows eight additional screens. Pa-
rameters of various vehicle elements and systems are
shown on the display.
Attention
!
The diagnostics of operational parameters is
more informative while driving. Thus, this mode should
be used only on the even ground without obstacles and
other road users.
Never use the mode for diagnostics of operation-
al parameters on public roads, because reading and
evaluating information from the screens will cause the
driver to pay less attention to the situation on the road.
The mode for diagnostics of operational parameters
can be activated only when alarm is on.
To view the display screens in the operational
parameters diagnostics mode:
1. Turn on the alarm.
2. Rotate the instru-
ments-and-starter switch key to
position «ON».
3. Within 15 seconds,
press the accelerator or the
brake pedal five times, or turn
on the high beam ten times. The
message 1 appears on the dis-
play.
Then the message 2 ap-
pears on the display.
4. To view the next eight
screens use the buttons
.
To exit the mode for di-
agnostics of operational parameters, turn off the alarm.
7-6
Message 1
or
Message 2