Replacing The Bulbs; Safety Requirements - KAMAZ 5490 Operation Manual

REPLACING THE BULBS

SAFETY REQUIREMENTS

1. Prior to replacing the bulbs, de-energize the
harness having rotated instruments-and-starter key to po-
sition «0 - all is OFF» or disconnect from storage battery.
2. When replacing the bulb, do not touch the
bulb barehanded. Hold it by plug or bulb socket, or, if
needed, you may hold by glass bulb using clean dry cloth
or clean dry gloves.
3. Avoid water getting onto bulb and spotting the
bulb.
4. If any spots, wipe the cold bulb using spirit and
dry cloth.
5. Inspect for corrosion on contacts, eliminate if
discovered.
6. When installing new lamps, take care of correct
arrangement of sealing gaskets.
When replacing blown bulbs, their type and pow-
er must be considered.
Replacement of lighting products with LEDs
should be carried out at the service center.
REPLACING THE BULBS
Replacing the additional lighting bulbs for
poor visibility conditions
1. Take apart the locking lug cover, placed under the
bumper, and remove it (see Fig. Additional lighting bulb for
poor visibility conditions).
2. Remove the cable cap on the lamp.
3. Remove the clamping spring.
4. Pull out the bulb.
5. Insert the new bulb into the socket, so that the
lamp cap enters the slot.
6. Secure the clamping spring, connect the plug with
the bulb contact.
7. Close the cover.
1
2 3
7-36
Additional lighting bulb for
poor visibility conditions
1 - additional lighting bulb for
poor visibility conditions;
2 - cover;
3 - locking lug