KAMAZ 5490 Operation Manual page 215

Glow plug
- Dismantle the air intake, rubber cap
protecting the glow plug, disconnect the leads,
unscrew the ignition plug and remove carbon
deposit from it.
- check the glow plug rubber cap for
mechanical damage, and in case of detection,
replace the glow plug.
Combustion chamber
Clean up the ∅ 1.5 mm hole for air supply to the
ignition plug
Fuel system
Check the fuel pipe for leakage; tighten up clamp
connections, if necessary.
Fluid system
Clean up the heat exchanger
Check the fluid system for leakage; tighten up
clamp connections, if necessary.
Special purpose
wrench, clean rags,
Visual inspection
benzene (acetone),
screwdriver.
КО-13 wrench,
Visual inspection
screwdriver
Visual inspection screwdriver
КО-13 wrench,
screwdriver,
Visual inspection
brush,
cooling liquid
КО-13 wrench,
Visual inspection
screwdriver
17
tank for
+
Every
500h
Every
500h
+
Every
500h
+