Ethernet Control Interface - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
5. UBEX Concept 5. UBEX Concept
5.3. Ethernet Control Interface
The endpoint device can be controlled via Ethernet port. This interface supports any third-party system
controller with LW3 command protocol. The interface can be used to configure the device with Lightware
Device Controller and establish the connection to Lightware Device Updater software and perform firmware
update.
Two Ethernet connectors provide a wide range of application possibilities:
▪ Control the device
▪ Firmware update
▪ Create a local network
▪ Daisy chain connection
Port Diagram
Port diagram of the Ethernet interface for the F110 model
Number of the Gigabit Ethernet Ports
The following table shows the number of the Gigabit Ethernet ports by endpoint models.
Endpoint model
UBEX-PRO20-HDMI-F100
UBEX-PRO20-HDMI-F110
UBEX-PRO20-HDMI-R100 2xMM-2xDUO
UBEX-PRO20-HDMI-R100 2xSM-2xDUO
UBEX-PRO20-HDMI-R100 2xMM-QUAD
UBEX-PRO20-HDMI-R100 2xSM-QUAD
UBEX-PRO20-HDMI-R100 2xSM-BiDi-DUO
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
Number of Gigabit Ethernet ports
2
3
1
1
2
2
2
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
Ethernet Interface - Example
The transmitters are connected to each other via LAN, the receivers connected to the transmitters via optical
fiber or DAC cables.
This way the laptop can control the system with Ethernet commands:
▪ UBEX transmitter (1-3).
▪ UBEX receiver (1-3).

ATTENTION! When one of the extender is in firmware update mode, the Ethernet communication will be
lost during the update procedure.
65 65