Removing And Replacing The Front Door; To Remove The Front Door; To Replace The Front Door; Removing And Replacing The Side Panel - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

7.2

Removing and Replacing the Front Door

In the process of removing and replacing a FRU, it might be necessary to remove the
front door of the Sun StorEdge 3900 and 6900 series storage system. This section
describes how to remove and replace the front door of the storage system.
No tools are required to remove the front door.

To Remove the Front Door

1. Open the front screen door.
2. Reach inside of the door and push down on the lever attached to the spring of the
top hinge pin.
This causes the hinge pin to retract into the door.
3. Tilt the door out from the top mounting bracket.
4. Remove the door and set it aside.

To Replace the Front Door

1. Tilt the door and insert the bottom hinge pin with the outside hole of the bottom-
left mounting bracket.
2. Reach inside the door and push down on the lever attached to the spring of the
top hinge pin.
This causes the hinge pin to retract into the door.
3. Align the top hinge pin with the outside hole of the top-left mounting bracket.
4. Release the lever.
The hinge pin extends into the mounting bracket.
7.3

Removing and Replacing the Side Panel

The tool required when removing or replacing the side panel is:
7-2 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002