17.2.1
Removing an Access Door
1. At the top of the door, pull up the spring-loaded pin and remove the peg of the
door from the top hinge bracket of the cabinet.
2. Lift the bottom peg out of the bottom hinge bracket and remove the door from the
cabinet.
3. Repeat
17.2.2
Installing an Access Door
1. Insert the door onto the bottom peg of the bottom hinge bracket of the cabinet.
2. At the top of the door, pull down the spring-loaded pin and insert the peg of the
door into the top hinge bracket of the cabinet.
17.3
Kick Plate Assembly Replacement
Note – The bottom system kick plate is NOT a step. Do NOT use the kick plate to
gain access to the high-level components. Obtain a proper stool if required.
Excessive weight on the kick plate bends the door support brackets.
17.3.1
Removing a Kick Plate Assembly
1. Use a pull-turn motion to release the spring-loaded captive locking pin on the left
side of the mounting tube and pull the kick plate assembly outward from the
mounting bracket (
Step 1
and
Step 2
for each door, as required.
FIGURE 17-1
Chapter 17 Mechanical Components Replacement Procedures
).
17-3