Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 132

creatediskpools(1M)–Creates disk pools that map to physical LUNs on the
specified Sun StorEdge T3+ array. These disk pools can then be used to create
VLUNs. This command is typically called by the modifyt3config command
and not run directly by the user.
createvezone(1M)–Creates an HBA alias and zone for the virtualization engine,
initiator, and zone name specified. You can also add in to zones when they are
created.
createvlun(1M)–Creates VLUNs for the virtualization engine, disk pool, size,
and number specified.
delfromvezone(1M)–Removes a VLUN or HBA from the zone for the
virtualization engine, initiator, and zone name specified.
failbackt3path(1M)–Resets the active path through virtualization engines to
Sun StorEdge T3+ arrays. When a virtualization engine loses its connection to a
Sun StorEdge T3+ array, it routes all I/O traffic through the alternate port, which
causes a failover on the Sun StorEdge T3+ array. After the path is restored, the
virtualization engine continues to route I/O traffic through the alternate path.
Use the failbackt3path command to restore the I/O path to the correct Sun
StorEdge T3+ port.
getdpspace(1M)–Returns the available space in the disk pool in Gbytes.
listve(1M)–Returns a list of the specified virtualization engine components that
are found by querying the system.
listvemap(1M)–Returns a list of the specified virtualization engine components
from the configuration map file. This command provides better performance than
the listve command, if the virtualization engine map file is up to date.
resetsandb(1M)–Clears the SAN databases on the virtualization engines and
resets both engines.
resetve(1M)–Resets the specified virtualization engine.
restorevemap(1M)–Restores the configuration from the saved map file to the
specified virtualization engine.
rmdiskpools(1M)–Removes disk pools and all VLUNs in the disk pool for the
specified Sun StorEdge T3+ array LUNs. This command is typically used when
you are reconfiguring the Sun StorEdge T3+ array. This command is usually
called by the modifyt3config command and not run directly by the user.
rmvezone(1M)–Removes the zones for the virtualization engine, initiator, and
zone name specified.
rmvlun(1M)–Removes the VLUNs for the virtualization engine, disk pool, and
VLUN target IDs specified.
savet3map(1M)–Records all Sun StorEdge T3+ array configuration information
in a file that can be used by the virtualization engine.
savevemap(1M)–Saves the current configuration of the specified virtualization
engine in a map file.
5-54 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002