Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 169

Note – For Sun StorEdge 3900 and 6900 series systems, all Sun StorEdge T3+ arrays
in a cabinet must use the same password. If one of the other arrays already has a
password set, you must use the same password for the new array.
:/:<1> passwd
OLD password:
NEW password: new password
NEW password (confirm): new password
:/:<2>
9. Type quit to exit the telnet session.
10. Type the following to transfer the syslog.conf file to the array:
msp0# ftp t3b0
Connected to t3b0.
220 192.168.0.40 FTP server ready.
Name (t3b0:root): root
331 Password required for root.
Password: password
230 User root logged in.
ftp> put /opt/SUNWsecfg/etc/syslog.conf /etc/syslog.conf
200 PORT command successful.
150 Opening ASCII mode data connection for /etc/syslog.conf
226 Transfer complete.
local: /opt/SUNWsecfg/etc/syslog.conf remote: /etc/syslog.conf
242 bytes sent in 0.00072 seconds (328.23 Kbytes/s)
> quit
11. Type:
msp0# /opt/SUNWstade/bin/config_solution
12. Start the Storage Automated Diagnostic Environment tool and rediscover the new
cabinet.
Refer to the Storage Automated Diagnostic Environment User's Guide for detailed
instructions on discovery.
To set up the configuration of the Sun StorEdge T3+ array(s) in the cabinet that was
just added, continue with the following steps.
Return
Chapter 10 Servicing the Expansion Cabinet 10-11