Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 24

Chapter 6 contains a brief overview of the functionality provided by the Storage
Automated Diagnostic Environment software to perform fault detection and
isolation on the Sun StorEdge 3900 and 6900 series storage subsystems.
Chapter 7 describes the preparation to service the field-replaceable units (FRUs) in
the storage system.
Chapter 8 presents the general instructions about the placement of FRUs and how to
install and remove FRUs from the storage system.
Chapter 9 discusses the removal and replacement of the Ethernet hub.
Chapter 10 gives instructions for the removal and replacement of FRUs in the Sun
StorEdge expansion cabinets.
Chapter 11 provides instructions for repair and replacement of the service panel.
Chapter 12 describes the removal and replacement of the service processor.
Chapter 13 tells the procedures for removing and replacing the Sun StorEdge
network FC switch-8 and switch-16 switches.
Chapter 14 gives instructions for removing and replacing Sun StorEdge T3+ array
partner groups.
Chapter 15 describes the removal and replacement of the virtualization engines.
Chapter 16 discusses how to service the network terminal concentrator (NTC)
hardware, which provides support for the Sun StorEdge Remote Response software.
Appendix A contains part numbers of the Sun StorEdge 3900 and 6900 series FRUs.
Using UNIX Commands
This document may not contain information on basic UNIX
procedures such as shutting down the system, booting the system, and configuring
devices.
See one or more of the following for this information:
Solaris Handbook for Sun Peripherals
AnswerBook2™ online documentation for the Solaris™ operating environment
Other software documentation that you received with your system
xxiv Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
®
commands and