Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 170

Note – Refer to
conventions to ensure that the name correctly corresponds to the location in the
cabinet.
13. Run the runsecfg(1M) command to start the character user interface.
14. Select the T3+ Configuration Utility from the Main menu.
15. When prompted, type the password for the Sun StorEdge T3+ array.
16. Select the Configure T3+ option.
17. Select the host name(s) of the Sun StorEdge T3+ array(s) that you added.
18. Select the Default or Custom option to configure the new Sun StorEdge T3+ array.
This step takes approximately two to three hours depending on the configuration of
the Sun StorEdge T3+ array.
10-12 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
or
FIGURE 3-1 FIGURE 3-2
for specific array locations and naming