Figure 8-5 Filler Panel And Trim Strip Location - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

FIGURE 8-5
6. If the storage system is not bolted to the floor, extend the stabilizer legs.
The stabilizer legs are located under the front of the storage system. Refer to the Sun
StorEdge 3900 and 6900 Series Version 1.1 Installation Guide for detailed instructions.
Caution – You must extend or retract the stabilizer legs as a pair. Make sure that the
levelers have been adjusted before attempting to move the stabilizer legs.
7. Install the FRU.
Refer to the section Section 8.2, "FRU Placement" on page 8-3.
8. Route the power cables from the FRU to the power sequencer(s).
A storage system that is ordered without all possible FRUs installed has the power
cables routed as shown in
8-8 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
Installed FRU
Trim strip
Filler panel
Filler Panel and Trim Strip Location
FIGURE 8-6
.