To Gain Access To The Serial Port Of The Storage Service Processor - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

2. Using the terminal emulator of your choice, configure the emulator with the
following parameters:
# of Bits:8
Stop Bits:1
Parity:None
Flow Control:None
Baud Rate: 9600 BPS
3. Follow the steps appropriate for your software to complete the serial connection
to the Storage Service Processor.
To Gain Access to the Serial Port of the Storage
Service Processor
If you are not using the Sun StorEdge Remote Response service:
If you receive the following prompt, login as usual.
msp0 console login:
If the prompt is not as shown above, type:
tty
You should see the following output:
/dev/console
This output indicates that the last login was not properly terminated. You can
now perform the functions you need to perform.
If you are using the Sun StorEdge Remote Response service:
When the connection is complete, the following prompt is displayed:
annex:
Chapter 12 Servicing the Storage Service Processor 12-3