Notch
FIGURE 8-7
5. To remove and replace a CD-ROM or a tape drive:
a. Loosen the three captive screws securing the device to the tray.
b. Remove the mounting plate of the device being replaced and attach it to the
replacement device using the same screws.
c. Set the replacement device SCSI address to 6 for a CD-ROM drive, or 5 for a
tape drive.
d. Secure the replacement device to the caddy by tightening the three captive
screws on the mounting plate.
e. To complete the replacement, reverse Step 1 and Step 2.
Note – The tape drive must be installed on the side nearest the key switch for
cooling purposes.
6. To install a tape drive for the first time:
a. Remove the filler panel by loosening the three captive screws and then
removing the panel.
8-8
Sun Enterprise 6500/5500/4500 Systems Reference Manual • April 1998
Removing and Replacing the media tray