Front Door Interlock Switch
Required Tools
Snap ring pliers with angled tip, diagonal cutters
To Remove the Front Door Interlock Switch
1. Remove power from the library.
Caution – DO NOT disconnect the power cord from facility power or the library.
The power cord is the only means of grounding the chassis and helping to prevent
electrostatic discharge (ESD) damage.
2. Connect your ESD wrist grounding strap to the closest grounding point on the
frame of the library.
3. Remove the top, left, and right cosmetic panels as shown in "Top, Right, and Left
Panels" on page 92.
4. Open the front door.
5. From the left lower side of the library, locate and disconnect the front door
interlock switch connector J1, which is plugged into SW2_J1 connector. See
(
FIGURE 4-8
6. Using snap ring pliers, remove the snap ring that holds the interlock switch.
7. Lift the interlock switch and its cable up through hole.
Replacing the Front Door Interlock Switch
Follow the removal instructions in reverse order.
110
Sun Enterprise Tape Library 7/3500 Field Service Manual • July 1997
).