To Make An Ethernet Connection To The Console Port Of The Storage Service Processor - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

Refer to the "Servicing the Storage Service Processor With the Sun StorEdge Remote
Response Enabled" on page 12-7 for instructions on responding to the OPIE
challenge.
To Make an Ethernet Connection to the Console Port
of the Storage Service Processor
This option is available only if the Sun StorEdge Remote Response service is
installed on the subsystem.
1. Configure your Ethernet terminal software so the terminal appears as IP address
10.0.0.n, subnet mask 255.0.0.0, no DNS, no gateway.
Note – If the Storage Service Processor LAN has been reconfigured to a domain
other than 10.0.0.n, you must obtain the valid Ethernet address from the
administrator of the new domain.
Connect the Ethernet port of the terminal to the NTC ENET port on the service
panel using the Ethernet crossover cable (part number 530-2149-01).
2. Type:
telnet 10.0.0.3
Note – If the Storage Service Processor LAN has been reconfigured to a domain
other than 10.0.0.n, you must obtain the valid Ethernet address from the
administrator of the new domain.
The following output is displayed:
Trying 10.0.0.3...
Connected to 10.0.0.3.
Escape character is '^]
3. Type:
2
12-6 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002