Servicing The Storage Service Processor Without The Sun Storedge Remote Response Enabled; To Connect To The Storage Service Processor - Sun Microsystems StorEdge 3900 Series Reference And Service Manual

12.4 Servicing the Storage Service Processor
Without the Sun StorEdge Remote
Response Enabled
This section contains procedures for servicing the Storage Service Processor when
you do not have the Sun StorEdge Remote Response enabled.

To Connect to the Storage Service Processor

1. Establish a connection to the Storage Service Processor.
a. Connect one end of the standard cable into the serial console port of the service
panel.
b. Connect the other end of the standard cable to an available serial port on one of
the following devices:
The cables and DB9 and DB25 adapters are shipped with the storage system.
2. From the onsite system, establish a connection to the Storage Service Processor.
The commands used to make the connection varies, depending on the onsite system.
For example, from a Solaris server, you would type:
# tip -9600 /dev/ttyb
Connected
When the connection is made, press Return.
3. Log in as root:
Console login: root
Password: password
12-12 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002
Laptop
Workstation
Server