Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 128

Note – If your passwords on the Sun StorEdge T3+ array are null, do not set this
variable. Also, only use this variable if you use the same password for each Sun
StorEdge T3+ array.
msp0# PASSWD=password
msp0# export PASSWD
If the environment variable is not set to the Sun StorEdge T3+ password, the
command fails.
The commands to configure the Sun StorEdge T3+ array are described briefly here.
For a complete description of a command and its function, refer to the individual
man(1) pages.
addtot3group(1M)–Adds a WWN to a Sun StorEdge T3+ array group. This
command is valid only on Sun StorEdge 3900 series that have volume slicing
enabled.
createt3group(1M)–Creates a group on a Sun StorEdge T3+ array and
associates a WWN with that group. The group is used to mask LUN permissions.
Only valid on Sun StorEdge 3900 series with volume slicing enabled.
createt3slice(1M)–Creates slices on a Sun StorEdge T3+ array volume. This
command is valid only on Sun StorEdge 3900 series that have volume slicing
enabled.
checkt3config(1M)–Checks the current Sun StorEdge T3+ array configuration
with the previously saved configuration. This checking is done by running the
Sun StorEdge T3+ array commands ver, vol list, vol stat, volslice
list, lun perm list, lun map list, lun wwn list, hwwn list, port
list, port listmap, sys list, and fru stat and comparing the output
with the previously stored configuration information. Any changes to the
information are reported.
deletefromt3group(1M)–Deletes a WWN from a Sun StorEdge T3+ array
partner group. This command is valid only on Sun StorEdge 3900 series that have
volume slicing enabled.
enablet3slicing(1M)–Enables the volume slicing system parameter for the
specified Sun StorEdge T3+ array. This command is valid only on Sun StorEdge
3900 series.
listt3map(1M)–Lists various slice, volume, group, and WWN information about
a Sun StorEdge T3+ array. This command is valid only on Sun StorEdge 3900
series that have volume slicing enabled.
listt3slice(1M)–Displays slice information about a Sun StorEdge T3+ array
volume. This command is valid only on Sun StorEdge 3900 series that have
volume slicing enabled.
5-50 Sun StorEdge 3900 and 6900 Series 1.1 Reference and Service Manual • July 2002