9
C H A P T E R
Servicing the Ethernet Hub
This chapter describes the removal and replacement of the Ethernet hub.
This chapter is organized as follows:
"To Remove the Ethernet Hub" on page 9-1
"To Replace the Ethernet Hub" on page 9-3
TABLE 9-1
TABLE 9-1
FRU Description
Ethernet hub (with rack kit)
The following tools are required when servicing the Ethernet hub:
1/4-inch slotted screwdriver
9/32-inch nut driver
To Remove the Ethernet Hub
1. Open the front door of the storage system.
2. Remove as many of the filler panels and trip panels as necessary to remove the
Ethernet hub.
3. Unplug the power cable from the Ethernet hub to be removed.
4. Open the back door of the storage system.
5. Remove the left side panel (if possible).
See Section t, "To Remove the Side Panel" on page 7-3.
lists the FRU associated with the Ethernet hub:
Ethernet Hub FRU List
Part Number
370-4170-01
9-1