Sun Microsystems StorEdge 3900 Series Reference And Service Manual page 83

Save Sun StorEdge T3+ Array Configuration–Updates the Sun StorEdge T3+
array snapshot file after reading the array configuration. This information is
saved on the Storage Service Processor to be reused if needed. For example:
Busy Sun StorEdge T3+ Array(s)
------------------------------
NOTE : Currently NO Sun StorEdge T3+ Array(s) are being
configured/restored.
AVAILABLE Sun StorEdge T3+ Array(s)
1) t3b0
2) t3b1
3) ALL
4) Return
Select option above:> 2
Backing up Sun StorEdge T3+ Array configuration parameters to
Service Processor .....
Checking : t3b1 configuration.......
t3b1 Configuration matches with Standard config 1
Saving : t3b1 Properties.......
When you select this option, you can select from a list of the Sun StorEdge T3+
array partner groups or select all partner groups.
Configure Sun StorEdge T3+ Array–Steps you through a series of submenus that
enable you to reconfigure Sun StorEdge T3+ arrays. After the configuration is
successfully updated, the information is saved to the snapshot files. The snapshot
files reside in /opt/SUNWsecfg/etc/t3nn. Each directory contains information
about the individual Sun StorEdge T3+ arrays in the following files: port_list,
restore, savemap, ver, vol_stat, port_listmap, restore_sys, sys_list,
and vol_list. Supported RAID types include: RAID 1, RAID 5, and RAID
1/RAID 5. In the RAID 1/RAID5 mixed RAID types, each Sun StorEdge T3+
array in the group has a RAID 1 device consisting of three physical drives and a
RAID 5 device consisting of five physical drives plus a spare.
Chapter 5 Configuration Utilities 5-5